Dodge Dakota Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
26 Posts
Discussion Starter · #1 ·
This has taken a lot longer than I wanted but I finally got a chance to dyno my truck again. My baseline dyno run bone stock netted Max power at rear wheels 168.2 hp Max torque 232.5. I have sence installed Edelbrock TES Header to 3inch pipe to a magnaflow Hiflow Cat 3inch to Flowmaster 40 series muffler and a 3inch tail pipe out tucked behind rear wheel no tip. And an AEM Brute Force intake sytem. After the intake and exhaust my dyno run is Max power 193.81hp Max torque 263.41. For a total improvement of 25.61hp and 30.91ft-lbs at the rear wheels. I was happy but want to break the 300 ft-lbs range.

The next mod is pulleys and electric fan or the Hyperpac tunner from Hypertech I am counting my pennies now.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top