Dodge Dakota Forums banner
1 - 3 of 3 Posts
G

·
Discussion Starter · #1 ·
Hi, I have been on here before and asked a question about using 72-slams all around the dakota. I am putting a 500 HP, 800 pds engine in the dakota (club cab 98). I was gonna use slam-72's all around. I can get a real good deal on 2 of my buddies used HS-62's though, and was wondering if I should go 62's in the front then 72's in the back? I wanna be able to get alot of lift though so I can stick some 22's on and lay frame. And I am also wondering if the little bit of a bigger bag would help for hookup and stability when stepping on it. The question I am wondering should I take the deal and go 62's in the front and 72's in the back or 72's all around? Thanks alot for any advice!
 

·
Registered
Joined
·
464 Posts
I'd go 62's up front so you don't have to hack the hell out of the cup like i did and 62's or 72s out back you wont have any problem with lift. As far as hookin up that just depends on how you set your suspension up...4 link/3link/watts link whatever...monoleaf gets axel wrap like a mother. Hope this helps just ask and you shall recieve.
 

·
.
Joined
·
223 Posts
Im was running es62's in the front of my 03 and it went from crossmember on the ground to 33" (measured at center of wheel well w/flares) on stock control arms and 25" tall tires. I love them, rode like a boat (no shocks)
 
1 - 3 of 3 Posts
Top